INTACT Bike Power GEL battery YTZ10-S, YT10B-4

   40+ sold

Product No.:299-301

EAN:4250227524179

Manufacturer:INTACT

Manufacturer Nr:299-301

Shipping time: 2-4 business days (GER)

Availability:1000

50.21 EUR
incl. 19 % Tax excl. Shipping costs

QTY

INTACT Bike Power GEL battery YTZ10-S, YT10B-4

Bike Power GEL battery YTZ10-S, YT10B-4

Intact Bike Power Battery GEL YTZ10-S, YT10B-4

Width x Depth x Height = 150 x 87 x 96 mm
Cold start current: 200 A (DIN)

Our absolute top product for motorcycle batteries is the intAct Bike-Power Gel series.

This series was specially developed for modern motorcycles with various electrical consumers and ABS. By combining the fleece separators and the fixed electrolyte in gel, up to 30 % more power is achieved compared to conventional motorcycle batteries. The batteries also impress with very low self-discharge and very high vibration resistance.


br/>Information about treatment and maintenance of your battery

A battery is only an energy storage device and any energy removed must be returned to it immediately 100% by the generator of the vehicle or externally by a charger, if the energy balance is rather negative due to short-term use or due to generally few use times with longer stance phases.

To ensure a long battery life, you should observe the following:
- Use of the battery only for its intended purpose (starter batteries for starting and operating a vehicle with internal combustion engine).
- The surface of the battery must be kept clean and dry, no oils or liquids must be deposited on it to avoid the formation of leakage currents which can cause considerable self-discharge.
- If possible, check battery level at least every 6 months and top up with purified water if necessary (do not top up with accumulator acid).
- In case of high water loss, please have the function of the charge controller checked by a specialist. With an optimal installation location and normal requirements, your battery will consume little to no water, but these factors are very different depending on use.

If your vehicle tends to have a negative energy balance due to use (short distances - longer stance phases - high comfort equipment - start-stop operation), the battery charge state should be checked at necessary intervals (2 - 3 months).

In order to always have sufficient starting safety and not to cause any damage to the battery, it should always be charged at least 75%. This can be determined with the open-circuit voltage or with an acid lifter.
Normal voltage:
12.51 V - 12.57 V = 75 % charged
12.69 V - 12.75 V = 100 % charged

Acid density:
1.25 kg/l = 75 % charged
1.28 kg/l = 100 % charged

This state of charge should at least have the battery, even if it still works with less, but this is still due to its durability.

Optimal would be 100 % charge - for 100 % use!

Since today's vehicle generation places a considerably higher electrical demand on the battery (due to its extensive comfort and electronic equipment), even newer vehicles can quickly lead to a negative energy balance. If most of the energy generated is required by the on-board power supply and the remaining energy is no longer sufficient to fully charge the battery.

For vehicles that are only used seasonally (convertibles, motorcycles, tractors, harvesting vehicles, construction machinery and construction vehicles), the same charge requirements must be observed for the battery as described above.

Check the charge (open-circuit voltage) of your battery every 2 months at the latest and recharge it if necessary. Due to the continuous chemical process, every battery is subject to self-discharge, which inevitably leads to the deepest discharge of your battery if this is not compensated by charging. If this is still connected to the vehicle, the discharge may be even faster, as the vehicle may also consume a standby current. It is best to disconnect the battery.

deep discharge is not a warranty but always self-inflicted and usually associated with the total failure of the battery.

The ideal temperature to store a battery over a stance phase is 10 - 15 degrees. Higher temperatures accelerate self-discharge and the loss of water.

Eternal life the battery does not have nevertheless - the capacity is exhausted sometime.
Always full charge + normal load = slow reduction of capacity.
Insufficient load + high load = rapid reduction of capacity.

Technical data

Artikel:PW-299-301
EAN:4250227524179
Manufacturer:intAct
Execution:wartungsfrei
Category:Gel Batterien
Weight:2.7760
Depth:87.00 mm

Please note, that vehicle spare parts should only be installed by a qualified specialist workshop to ensure their proper function and the road safety of the vehicle.:

Customers who bought this product bought the following products also

 
Front sprocket 15tooth pitch 530 JTF33315
 250+ sold

Product No.: BTS-726.36.68

EAN: 824225202670

Manufacturer Nr: JTF333.15

Shipping time: 2-4 business days (GER)

Zbk rear sprocket 43tooth pitch 530 black JTR134043ZBK
10+ sold

Product No.: BTS-727.06.49

EAN: 824225313758

Manufacturer Nr: JTR1340.43ZBK

Shipping time: 2-4 business days (GER)

Did x-ring chain 530vx3/112 970632
5+ sold

Product No.: BTS-797.03.34

EAN: 4525516394215

Shipping time: 2-4 business days (GER)

Neutral switch NUS 360-721
Neutral switch NUS 102

Product No.: 360-721

EAN: 4054783045501

Manufacturer Nr: 360-721

Shipping time: on request

FERODO Sintered lining FDB 664 ST
Ferodo sintered lining FDB 664 ST

Product No.: 586-664

EAN: 5016687196375

Manufacturer Nr: 586-664

Shipping time: on request

DID Kette und ESJOT Räder ZVMX chain set for: APRILIA 1000 RSV4 R/Factory/APRC/ ABS, 09-15
D.I.D. PREMIUM X-Ring Chain Set for: Aprilia RSV4 1000 Factory, 09

Product No.: 824-052

EAN: 4054783137879

Manufacturer Nr: 824-052

Shipping time: on request