LSL MANTIS-RS for KTM 990 Super Duke R 09-11, without license plate light fitting for KTM Super Duke R8 990 2010-2010,

LSL MANTIS-RS for KTM 990 Super Duke R 09-11, without license plate light

Adjustable license plate holder for KTM 990 Super Duke R 09-11

LSL MANTIS-RS license plate holder

Making good bikes perfect. Following this motto, LSL has developed the license plate holder LSL MANTIS-RS.

It fits perfectly to your motorcycle and emphasizes the lines of your bike with its sporty design.

And as usual from LSL, one has thought of everything.
The model-specific bracket of the LSL MANTIS-RS allows replacement without further drilling or cutting on the vehicle.
The design fits perfectly to the rear of your motorcycle, using the original mounting points of the vehicle.
Against damage to the cables, sharp-edged feedthroughs are protected with rubber membrane grommets.

The license plate is made of 2 mm thick sheet steel, laser-cut, edged and weather-resistant black powder coated.
The fixation of the license plate in the correct position is done by an additional locking screw.

The, adjustable in width, turn signal brackets of the LSL MANTIS-RS are suitable for any type of accessory turn signals. This adjustment option allows you to find the right position for your turn signals. Adapting to the most diverse EU license plates is therefore no problem. The mounting holes of the turn signals have a diameter of 8 mm and are slotted to the side. This allows the installation of the turn signals without disconnection from the wiring harness.

Also the slider for mounting the rear reflector is individually adjustable. Adaptation to the different designs of EU license plates is therefore no problem.

The two supplied rubber washers serve the vibration-reducing screw connection of the license plate. An additional rubber buffer supports the license plate on the underside.

Details:

- model-related bracket
- infinitely adjustable turn signal holder
- slotted turn signal holder for easy mounting without cable separation
- infinitely adjustable reflector, E-approved
- suitable for European license plates
- infinitely adjustable tilt angle
- additional screw for optimum position security
- easy fixation without further work steps (eg. Drilling)
- easy mounting of the license plate through slotted holes

Included in the scope of delivery of the LSL MANTIS-RS are:

- Model-related bracket with mounting parts
- LSL MANTIS-RS license plate mounting plate
- Adjustable turn signal holders
- E-tested reflector with adjustable holder
- Mounting instructions

Notes:
- If side reflectors are mounted on your original license plate holder, these must be reattached in a suitable position or replaced with new ones.
- For the original turn signals is optionally available the special turn signal holder 280-975.

Tip:
If you have not found a model-specific license plate holder for your vehicle, then you will certainly find the universal license plate holder from LSL, which are available in many different designs.

Technical data

Media:

Info
Info